Today saw a user report that the reciprocating coal feeder could not work normally, the phenomenon of material plugging.After careful inquiry, the reason was found and a feasible solution was given.If your reciprocating coal feeder of the plugging material, don't try so hard, the below small make up the reciprocating to the cause of coal plugging material and solution, tell you, later will not have to worry about reciprocating coal feeder plugging material reciprocating phenomenon.
First, reciprocating coal feeder is through rotating spiral blade for conveying the material goes on, the blade and material has been friction, low power consumption, so the blade is easy to damage, so often should check whether the blade is damaged, if damaged, it immediately replaced.
Second, all the transmission part adopts the reciprocating coal feeder is floating connection way, it has a certain bearing range, so in the use of the material do not overweight, if too much material is easy to cause card, wall material.
Third, reciprocating to the coal conveying distance (not more than 30 meters, so let's narrow suspension bearing transverse dimensions among them, to avoid the possibility of material through the intermediate bearing of plugging material.
Finally, for materials, it is usually powdery, granular and small pieces of materials. If the materials are large or too sticky, it will cause material blockage.